HIGH PEFORMANCE

3D PRINT SERVICE

We specialize in high-performance polymers: PEEK, ULTEM™, PPSU, PPS, PSU, and carbon-fiber composites.


If you're looking for parts with extreme toughness, chemical resistance, or heat deflection, you've come to the right place.

HIGH PERFORMANCE POLYMERS

Choose from PEEK, CFPEEK, PEI (made from ULTEM™ resins created by SABIC), PSU, PPS, CFPA6, and more

HEAT RESISTANCE

Our materials perform at operating  temperatures up to 340°C extruded at 400°C and above, they are literally the worlds highest-performing polymers.

CHEMICAL RESISTANCE

Our materials exhibit excellent resistance to abrasion, chemicals, solvents, grease & oils, radiation, and a variety of other extreme environments.

HIGH-STRENGTH

Our polymers are designed to replace metal - comparable to Steel in strength and rigidity, often are used where metal cannot be, or as prototype material for high-end assembly parts. 

No matter the complexity, we work together with you to ensure parts meet your requirements.


From dimensional accuracy to layer adhesion, tool paths and crystallization -- we've got you covered. 

  • Bypass the learning stages

  • No Initial Investment

  • One-on-One with an Expert

  • Massive Cost Savings

RAPID PROTOTYPING

PART PRODUCTION

RESEARCH & DEVELOPMENT

UPLOAD YOUR PARTS BELOW

Fill out the form below, and we will contact you within 24 hours regarding your quote.

We will review your part, check pricing and printability, and contact you via email to complete the process. 


Alternatively, you can email your parts to printservice@visionminer.com

When you upload your files, we reserve the right to publish pictures and videos of the printing process, and complete. This does not include publishing any 3D files, Mechanical Drawings, or specific design details in regard to your part; rather, this type of content simply shows the process and end results of 3D printing. We take care to ensure IP and trade secrets, new methods, techniques, or designs, are not shown which could infringe on intellectual property. If you would like to opt out of this, simply send an email to contact@visionminer.com with "NDA Request" in the subject line, and we will keep all of your data private. This may or may not result in increased pricing for your parts. We take IP very seriously, as well as education, and work with you directly to ensure satisfaction with our services.
ULTEM™ resin is a trademark of SABIC or it's subsidiaries or affiliates.